钛合金薄壁结构件磨削加残余应力有限元仿真.docVIP

毕 业 设 计 专 业： 机械设计制造及其自动化 钛合金薄壁结构件磨削加工残余应力有限元仿真 Grinding and residual stress simulation of titanium alloy made thin wall structure 中文摘要 论文主要内容和成果如下：1．2．3．．．本文研究，虽然其具体，但就。关键词：ABSTRACT Titanium alloy have been widely used in different fields, such as aeronautics and astronautics, electrolytic industry, power station, petrochemical industry and medicine. It is a material of high mechanical property. However, Ti-alloy’s outstanding material qualities are going along with hard manufacturing properties, which usually well manifested itself in the last processing step, namely, grinding. Consistently, there will be propagated tensile stress leaving on the finished surface, which can impair material’s anti-corrosive quality and fatigue resistance; in the long run, any kind of residual stress can also cause creep, affecting the reliability and stability of a whole system. Therefore, avoiding the tensile stress on a Ti-alloy workpiece is a key issue and of great importance. Meanwhile, as the high requirements of surface stress measurements and delicate measuring device, the thinking of improving product quality by trial and error is too costly, inefficient and impractical. Alternatively, finite element simulation, the substitute, forerunner, or theoretical tester for real problem is valuable. For cutting and grinding are non-linear physical process, they involve coupling of force and temperature, involve material failure and lattice deformation. Therefore, a successful simulation bears a lot with using a competent software. This dissertation also compares several big finite element softwares, and gives references to simulations by Abaqus. The conclusion can be used to improve grinding process and refine abrasive particles. Main works and results of the thesis are as follows. 1. Summations of grinding process to the surface qualities of workpiece. 2. Comparisons of softwares and simulation models. 3. Parameter analysis to the surface qualities. 4. Methods of building Abaqu