翻盖注射模的设计.docVIP

第 第 PAGE \* MERGEFORMAT 1 页 共 NUMPAGES \* MERGEFORMAT 1 页 学号：常 州 大 学 毕业设计（论文）（2014届）题 目 翻盖注射模设计 学 生 学 院 机械工程学院 专 业 班 级 材料成型与控制工程 校内指导教师 专业技术职务 副教授 二○一四年五月 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT I翻盖注射模设计摘要：本课题主要目标是设计一需要侧抽芯机构的翻盖注射模具。首先对塑件进行工艺性分析，通过对塑件材料，外形等相关因素的分析确定模具设计方案。选择模具的浇注系统和顶出机构。设计的关键是侧抽芯机构的设计。由于采用一模四腔，需要八个侧抽机构，且型芯、型腔分布较复杂，但塑件侧抽芯距离较短，所以本设计采用了一种肘杆式的抽芯方案，同时完成对模具内部塑件两侧的侧抽。设计涵盖了模具设计的所有结构，包括：模具的型腔结构、型芯的结构、导向机构、推出机构、浇注系统、排气系统、模温调节系统等，还包含有，如：动模型芯、定模型芯等主要零部件加工工艺要求。正确选择注射机，并完成对开模行程、注射压力、最大注射量、锁模力的校核。正确选择模架，校核推出行程。关键词：翻盖；注射模；侧抽芯。 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT IIThe design of the injection mould for coverAbstract:The main objective of this project is to design a mould for cover with side core-pulling mechanism. Firstly, manufacturability analysis of plastic parts.Through the analysis of appearance and other related factors of plastic of material to determine the scheme of mold design.Select the mould gating system and ejection mechanism.The key to the design is to the design of side core-pulling mechanism.With one module and four cavities and need eight side pumping mechanism. The distribution of core and cavity is complex.For the distance of side core-pulling of plastic pieces is short,So for this project we chose a link mechanism as side core-pulling mechanism.At the same time it can complete the the side drawing of mold plastic parts on both sides.The design covers all structure of mold design, including: the cavity structure, the molds core structure, guide mechanism, ejection mechanism, gating system,exhaust system, mold temperature regulating system, Also it contains, such as:oblique pin, block, the wedge block, dynamic model of the core,fixed mold core,guide pillar the guide sleeve, and other major parts processing requirements.Make the correct choice of injection machin