RBS2216 (参照RBS2116看).pptVIP

1,RBS2216 Product Description * high-capacity indoor base station. * up to six Double Radio Units (DRU) * GPS synchronization * Enhanced Data rate for Global Evolution (EDGE) * Three RBS 2216 cabinet variants(-48v,230v,24v) External Connections 2, RBS2216 Installation Earth grounding the cabinet connecting the DF ESB CABLE Connecting AC power connecting +24V DC Connecting -48v Connecting the antenna system IDM-12 Unit Description The IDM-12 is a variant of the Internal Distribution Module (IDM). PSU-DC-31 and PSU-AC-31 Unit Description The PSU-DC-31 is a variant of the Power Supply Unit (PSU) that converts DC to DC (PSU-DC). RX-Splitter-03 Unit Description The RX-Splitter-03 is a variant of the Receiver splitter (RX splitter). An RX splitter distributes RX signals between Double Radio Units (DRU) in the same RBS or between RBSs. TMA-CM-03 Unit Description The TMA-CM-03 is a version of the Tower-Mounted Amplifier Control Module (TMA-CM). TMA-CMs supply power to, monitor, and control TMAs. 3RBS2216Antenna and RF Connections? Dual-Band 3×2|3×2 Combined Antennas marked 1 in the figure below use one frequency band, and antennas marked 2 use the other. 3+3+4 Mixed Combined and Uncombined 3×4 Combined CBC/DL/RAN GPS solution synchronization RJ-45 GPS External synchronization bus RJ-45 ESP External synchronization bus RJ-45 ESB1 External alarm inputs 36-pin SCSI connector Ext. Alarm G.703-4, transmission link 4 RJ-45 Port D G.703-3, transmission link 3 RJ-45 Port C G.703-2, transmission link 2 RJ-45 Port B G.703-1, transmission link 1 RJ-45 Port A Description Connector Type Interfaced 　 　 BIOM port 1 X4-D 　 　 BIOM port 2 X4-C 　 　 IOM port 1 X4-B 　 　 IOM port 2 X4-A 传输端口D(绿) V11 Ext. alarm X1 传输端口C(绿) V10 G.703, Port C X18-D 传输端口B(绿) V9 G.703, Port D X18-C 传输端口A(绿) V8 G.703, Port A X18-B 外部告警(黄) V5 G.703, Port B X18-A 内部告警(黄) V4 DC in X22 近端指示(黄) V3 Y1-6 (y-links) X10-B 正常工作(绿) V2 Y7-12 (y-links) X10-A 硬件故障(红) V1 GPS X2 (DB) 用途 指示灯 OMT U1 近/远端