rolsen_lcd_tv_rl-17s10 液晶电视维修.pdf

COLOR TFT-LCD TV SERVICE MANUAL MODEL : RL-17S10 CAUTION !! BEFORE SERVICING THE TFT-LCD TV, READ THE SAFETY PRECAUTIONS IN THIS MANUAL. RL-17S10 SERVICE MANUAL PAGE:1 CONTENTS Contents 2 Safety Precautions 3 Servicing Precautions 4 Specifications 5 Control Descriptions 10 External In/Out Ports 13 Adjustment 14 Block Diagram 18 Schematic Diagram 19 Wave Form 20 Troubleshooting 25 Replacement Parts List 27 PCB Layout 34 Exploded View 39 RL-17S10 SERVICE MANUAL PAGE:2 SAFETY PRECAUTIONS !! Important Safety Notice !! Many electrical and mechanical parts in this chassis have special safety-related characteristics. These parts are identified by in the Schematic Diagram and Replacement Parts List. It is essential that these special safety parts should be replaced with the same components as recommended in this manual to prevent Shock, Fire, or other Hazards. Do not modify the original design without permission of manufacturer. Leakage Current Hot Check (See below Figure) Plug the AC cord directly into the AC outlet. Do not use a line Isolation Transformer during this check. Connect 1.5K/10watt resistor in parallel with a 0.15uF capacitor between a known good earth ground (Water Pipe, Conduit, etc.) and the exposed metallic parts. Measure the AC voltage across the resistor using AC voltmeter with 1000 ohms/volt or more sensitivity. Reverse plug of the AC cord into the AC outlet and repeat AC voltage measurements for each exposed metallic part. Any voltage measured must not exceed 0.75 volt RMS, which is, corresponds to 0.5mA. In case any measurement is out of the limits specified, there is possibility of shock hazard and the set must be che