（毕业设计论文）《基于AT89C51单片机的热释电防盗报警系统的设计》.docVIP

河南理工大学本科毕业设计（论文）说明书 PAGE 14 摘 要 本论文从硬件和软件两方面对系统进行了详细的设计。介绍了核心芯片的选型，外围电路的连接，芯片与芯片之间的连接电路，程序设计方法和相应的软件。系统电源用7805、7809芯片输出5V、9V电压，通过稳压模块给系统供电。整个设计采用模块化思想，主机采用AT89C51实现控制，由热释电传感器和振动位移传感器对住宅的模拟信号（人体发出的红外信号、引起的振动信号等）进行自动监测，当检测到异常情况，产生数字信号输入单片机，单片机根据输入信号，输出给蜂鸣器报警，做出反应处理。复位电路采用低功耗，四引脚的IMP812监控芯片。系统硬件电路简单、安装方便、操作简单，并且具有成本低的优点，可适用于各种类型的住宅和人群。 关键词：传感器； 单片机； 报警系统 ABSTRACT This paper from both hardware and software on the system carried out a detailed design. It introduced the Selection of the core chip, the external circuit connections, chip and the connection between the circuit chip, program design methods and the corresponding software. 7805,7809 chip system power output by 5 V, 9V voltage regulator module to the system through the power supply. The whole design is modular thinking, host AT89C51 used to achieve control, by the pyroelectric sensor and vibration displacement sensors for residential analog signal (the human issued by the infrared signal from the vibration signals, and so on) for automatic monitoring, When detected abnormal circumstances, producing a digital signal input SCM, the MCU according to the input signal and output to the buzzer alarm, to respond to treatment. Reset circuit using low-power, four-pin IMP812 monitoring chip. System hardware circuit simple, easy to install, simple operation, and has the advantage of low cost, applicable to all types of residential and the crowd. Key words: sensor； MCU； alarm system 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc200764129 摘要 PAGEREF _Toc200764129 \h I HYPERLINK \l _Toc200764130 ABSTRACT PAGEREF _Toc200764130 \h II HYPERLINK \l _Toc200764131 1 绪论 PAGEREF _Toc200764131 \h 1 HYPERLINK \l _Toc200764132 1.1 序言 PAGEREF _Toc200764132 \h 1 HYPERLINK \l _Toc200764133 1.1.1 防盗报警系统的构成 PAGEREF _Toc200764133 \h 2 HYPERLINK \l _Toc200764134 1.1.2 防盗报警器的分类 PAGEREF _Toc200764134 \h 2 HYPERLINK \l _Toc200764135 1.1.3 防盗报警系统在国内外的发展 PAGEREF _Toc200764135 \h 3 HYPERLINK \l _Toc200764136 1.1.4 防盗报警器的发展前景与趋势