8pcba生产注意事项(二).pptVIP

(2) The Machine Model (MM) represents a worst case HBM. It provide more realisticsimulation of actual damage normally obtained from a person holding a tool. EOS/ESDAssociation Draft Standard DS5.2 –1993 describes use of the HBM for device classificationand has been released for comment. (3) The Charged Device Model (CDM) simulates the damage resulting from a charged devicecontacting a metal grounded surface. This failure mode is very damaging and is associatedwith automated handling equipment and use of dip tubes. EOS/ESD Association DraftStandard DS5.3 –1993 describes use of the CDM for devi