电子式互感器合并单元的分析-电气工程专业论文.docxVIP

华 华 中 科 技 大 学 硕 士 学 位 论 文 II II Abstract There are many defects in traditional substation： devices from different manufacturers are difficult to achieve interoperability, a large number of cables are needed to transmit analog data, the low voltage devices can not be insulated from the high voltage devices ,so the insulation design is difficult. The traditional substation is unable to meet the demands of the development of the power system. Digital substation has a certain basis with the technical development . Electronic transformer and its universal digital interface-Merging Unit(MU) are the key parts of the digital substation, which have a strong research significance. This paper first analyzes the research background and significance of the digital substation and MU , builds the overall structure according to the functional design requirements of MU .Then demonstrates the design of the digital transformer which takes the MSP430 microcontroller as control core. And then the paper explains the detailed structure of the MU based on ARMFPGA, introduces the hardware circuits including the interface circuits between ARM and FPGA,ARM and the network controller DM9000 ， analyses the software realization of synchronous sampling control, receiving and processing data in different channels and the Ethernet communication. Again, to meet the requirements of strong real-time, high reliability, strong anti- interference capability in the digital substation, the transplant of embedded operating system in MU is studied. Finally, experiments on the electronic transformer and its MU are conducted. The output characteristics of the electronic transformer, the packet format of the MU output data and the packet loss rate are tested. In order to verify the overall performance, the output data of the MU are sent to the calibration system with the ratio error and the phase error checked. Experimental results show that the proposed design satisfies the requirements of real-time, interope