《新建年产71万吨告诉线材车间》毕业学术论文.docVIP

┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ 装 ┊ ┊ ┊ ┊ ┊ 订 ┊ ┊ ┊ ┊ ┊ 线 ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ 安徽工业大学 毕业设计（论文）报告纸 共 2 页 第 PAGE 1 页 新建年产71万吨告诉线材车间 摘要 钢铁是现在社会经济建设的重要资源，而线材又是其中的重要组成部分。 本设计旨在建立一个年产71万吨的高产热轧线材车间。产品规格范围：Φ6～Φ14mm线材，以常见的低碳钢为主展开介绍，简要介绍线材的生产规划流程过程：产品的规格、坯料的选择、加热炉的选择、轧机轧辊的选择与校核、冷却方式的选择等等。 本设计采用了连铸坯，可以减少金属的切损，又因连铸坯的组织结构较好，提高了产品的质量；同时通过采用连铸坯热装热送工艺，通过降低烧损、能耗和减少轧制间隙时间提高生产率。 本设计以优产高产为原则，主要体现在：加热炉为步进梁式加热炉；进出料采用侧进侧出；轧机采用高速无扭线材轧机；采用控制冷却技术，且轧后通过水冷箱和一套斯太尔摩冷却运输系统。 关键词：线材，轧机，坯料，加热炉 New annual output of 710,000 tons to tell the wire mill Abstract Iron and steel is now the important resources of the construction of social economy, and the wire is an important part of one. This design aims to build an annual output of 710000 tons of high yield of hot rolled wire rod plant. Common low carbon steel mainly introduced in this article, brief introduction of wire rod production planning process: product specifications, material selection, the selection of heating furnace, rolling mill roller selection and check, selection of cooling way and so on. This design uses the continuous casting billet, can reduce the metal cutting loss, and because of the continuous casting blank structure structure better, improve product quality; at the same time, through the use of continuous casting billet hot delivery and hot charging process, by reducing the burning loss, energy consumption and reduce rolling gap time to improve productivity. The design and production of high yield for the principle, mainly reflected in: the heating furnace for walking beam heating furnace; feeding the side inlet side; mill adopts high speed non-twist wire rod mill; controlled cooling technology after rolling, and through the water tank and a set of Stelmor cooling transportation system. Keywords：wire，roll，billet，furnace 共 4 页 第 PAGE 4 页 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295116534 引 言 PAGEREF _Toc295116534 \h 1 HYPERLINK \l _Toc295116535 1.线材的基本状况与高线生产简介 PAGEREF _Toc295116535 \h