（毕业论文毕业设计）-HFJ6371型车侧围装饰板卡扣的注射模设计.docVIP

PAGE HFJ6371型车侧围装饰板卡扣的注射模设计 摘 要 当今，随着世界经济的迅猛发展与人民的生活水平的普遍提高，汽车也越来越多的进入了普通家庭，因此带动了汽车工业的发展。而汽车业要实现高效率生产，模具是一个重要环节。用注塑模具来生产汽车饰品，不仅外表美观，而且经济实用，成本低。因此,注塑模设计的优劣与整个汽车工业的发展有着密切的联系。而CAD软件在模具设计中对模具设计方案进行分析和模拟来代替实际的试模，预测设计中潜在的干涉与缺陷等问题。 本设计中，论述了HFJ6371型车侧围装饰板卡扣的注射模设计过程，同时也论述了应用CAD软件进行二维实体建模，并对其进行可行性分析和工艺性分析，然后利用软件设计出浇注系统和各种成型零件，最后根据成型特点和生产要求生成标准模架的整个过程。在设计中，由于零件结构尺寸较小，要保证零件质量，需采用一模多（八）腔结构。且应用点浇口结构，以便有利于成型。 关键词：塑料注塑模；装饰板卡扣；CAD；点浇口 Abstract Today, with the rapid development of world economy and generally improve the living standards of people, cars are more and more into the average family, so bring the automobile industry. The automotive industry to achieve high efficiency, mold is an important part. Injection mold used to produce automobile accessories, not only looks beautiful, but also economical and practical, low cost. Therefore, the merits of injection mold design and development of the auto industry closely. And CAD software design of the mold in the mold design analysis and simulation to replace actual tryout, forecasting the potential to interfere with the design flaws and other issues. This design, the Model Side discussed HFJ6371 board deduction of injection mold decoration design process, but also discusses the application of CAD-D solid modeling software, and its feasibility analysis and process analysis, and then use software design the gating system and a variety of molded parts, and finally forming characteristics and production requirements under the standard mold of the entire build process. In the design, structure size as small parts, to ensure part quality, requires the use of a multi-cavity mold. And the application point of the gate structure, in order to facilitate molding. Keywords：Plastic injection mold；Decorative board buckle; CAD; point gate 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc265063826 摘要 PAGEREF _Toc265063826 \h I HYPERLINK \l _Toc265063827 Abstract PAGEREF _Toc265063827 \h II HYPERLINK \l _Toc265063828 第1章 绪论 PAGEREF _Toc2650638