路由器配置与管理.pptVIP

Slide 4 of 4 Purpose: Emphasize: Slide 1 of 1 Purpose: Emphasize: In release 12.0, there are new copy commands. These new commands treat the RAM, Flash, NVRAM, tftp, ftp, etc… as a file system. Since at the time when this class was developed, the most common IOS in the field is pre 12.0, these 12.0 commands are not covered in detail in this class. Slide 1 of 1 Purpose: Emphasize: This section introduces topics on managing your configuration file and IOS image. Slide 4 of 4 Purpose: Emphasize: Layer 4—On some Unix server, you may have to first create the file first before you can download the IOS image from the router to the tftp server. You can use the “touch” Unix command to create an empty file on the Unix server. Slide 1 of 1 Purpose: Emphasize: The show flash command is an important tool to use to gather information about your router memory and image file. Caution students that they must know that they are loading the correct and appropriate image. The name for the Cisco IOS image file contains multiple parts, each with a specific meaning: The first part of the image name contains the platform on which the image runs. In this example, the platform is C2500. The second part of the name identifies the special capabilities of the image file. A letter or series of letters identifies the feature sets supported in that image. In this example, the j indicates this is an enterprise image, and the s indicates it contains extended capabilities. The third part of the name specifies where the image runs and if the file is compressed. In this example, l indicates the file is relocatable and not compressed. Relocatable means the IOS can be ran from flash or from RAM. You should be careful in reading the Cisco IOS image filename. Some fonts display the lowercase letter “l” and the number 1 as the same character. How you type the characters will impact the ability of the router to load the files correctly. The fourth part of the name indicates the version number. In this ex