多变量均值向量控制图的若干研究及改进-工业工程与物流管理专业论文.docxVIP

上海交通大学硕士论文A 上海交通大学硕士论文 ABSTRACT II II ANALYSIS ON MULTIVARIATES CONTROL CHARTS FOR MEAN VECTORS ABSTRACT It is frequently required to control two or more quality characteristics simultaneously during statistical process quality control. So the multivariate quality control exists widely. When the statistical process quality control is performed for multi-characteristics in the course of product manufacturing, joint control of multi-characteristics cannot be replaced by separate control of each characteristic, because their control fields are different. Therefore, it is essential to study the multivariate control charts. For multivariate statistical process the usually recommended procedure is multivariate control chart, especially T 2 control chart and EWMA chart. In the retrospective phase the common covariance matrix is always unknown and several approximate distributions of statistic based on different estimators are compared. Calculation methods for upper control limit of different T 2 charts with different sample size m and quality dimensions p are proposed. An improved MEWMA chart based on successive differences estimator S2 is established. With different smoothing factor r and non-centrality parameter λ , the signal probabilities and ARL (Average run length) of two MEWMA charts are compared when two types of shifts in mean vector occur. A case study based on simulation is presented to show the different properties of several T 2 matrix is estimated. and MEWMA charts when common covariance KEY WORDS: multivariate process control； estimators for common covariance matrix； upper control limit； shifts in the mean value 上海交通大学硕士论文目录 上海交通大学硕士论文 目录 III III 目录 摘 要 ··································································································I ABSTRACT ··························································································II 第 一 章 绪论 ·············································································