EMC VNX 统一存储产品 SE 培训精编.ppt

*第 1 季度后才可以为 VNXe3300 订购 3.5 英寸闪存驱动器 VNXe3100 将只可以通过 Channel Express 订购 对于 VNX 系列，2.5 英寸驱动器、25x2.5 英寸驱动器磁盘阵列箱和磁盘处理器箱 (DPE)（针对 VNX5100、VNX5300 和 VNX5500）要等到在 2 月版的 Direct Express 和 Channel Express 中订购。届时，将只提供 10K rpm 300 GB 和 600 GB 2.5 英寸 SAS 驱动器。 2.5 英寸闪存驱动器将在 2011 年第 1 季度后提供。 当需要 15K rpm SAS 或 7.2K rpm NL-SAS（近线串行 SCSI）驱动器时，您将需要推介装有 3.5 英寸驱动器的 15 驱动器 DAE/DPE。 为遵守当前的最佳做法，建议只将 7.2K rpm NL-SAS 驱动器配置为 RAID 6 模式。此建议适用于所有等于或大于 1 TB 的驱动器。 *10K 驱动器是装在 3.5 英寸托架中的 2.5 英寸驱动器。 ** 对于 VNX 系列，存在每存储处理器的 iSCSI 端口总数为 8 这一限制（不管速度是多少），现在每个 X-Blade 最多可支持 256 TB 的容量（VNX5300 例外，它的每个 X-Blade 最多支持 200 TB）。 The servers on the top of the slide reflect the true value of unified storage by enabling servers to connect to VNX via SAN (iSCSI, Fibre Channel or Fiber Channel over Ethernet) and NAS. This picture illustrates a unified storage product with scalable X-Blades. The VNX 5300 supports up to 2X-Blades, the VNX 5500 supports up to 3 X-Blades, the VNX5700 up to 4 X-Blades and the VNX7500 up to eight. Each system can be configured with at least one X-Blade to be a failover standby blade (the 5300 and 5500 can be ordered with a single X-Blade if File HA is not critical). The 5700 and 7500 can also be configured with more than one standby blade, if desired. This is useful if you’re running two separate applications on different networks, or the environment is very critical and the pool of standby blades provides continued access even in the extremely unlikely event of a double blade failure. The failover between X-Blades is controlled by the Control Station (not shown). The Control Station is used for configuring the system, and for monitoring the health of the primary blades and initiating failover to the standby blade, if the primary blade fails. The VNX Series supports 1 or 2 control stations for increased availability. The VNX includes a fully integrated Block processing component, the Storage Processor. The new VNX models offer up to three times the performance of the previous generatio