高强度热轧钢板翻边特性数值仿真研究及实验验证-材料加工工程专业论文.docxVIP

II II 边缘部分开始出现破裂或宏观起皱时对应的翻边高度。 通过调整模具的尺寸及工艺参数，详细考察了多种材料的临界翻边 高度对拉伸翻边圆弧半径、压缩翻边圆弧半径、凸凹模及压边圈倒角、 凸凹模之间的间隙、压边力以及虚拟速度等因素的敏感性。 最后，根据模拟得到的模型形状及工艺条件，开发出一付可以用来 评价高强度热轧钢板的模具，并进行了实验验证。 关键词：高强度热轧钢板 翻边特性 数值仿真 敏感性分析 III III NUMERICAL SIMULATION ANALYSIS AND EXPERIMENTAL VALIDATION OF FLANGEABILITY OF HIGH-STRENGTH HOT-ROLLED STEEL PLATE ABSTRACT Energy conservation, consumption reduction of power, environmental protection and security are required as the development of new generation cars. With the advantage of excellent intension and temper, high stretch rate and processing hardening rate and light weight, high-strength hot-rolled steel plates are widely used in car chassis and subassemblies. So it is necessary for various forming properties of high-strength hot-rolled steel plates to be studied further. Besides, there are lots of flanging characters in auto-body panels. Usually, auto-body panels are flanged after drawing and edge-trimming. Thus, study of key simulation technologies of high-strength hot-rolled steel plate, analysis of flangablility of high-strength hot-rolled steel plate and cracking and wrinkling sensitiveness of mould parameters and procedure parameters are needed. It’s very important for high-strength hot-rolled steel plate to be used and promoted. This thesis focused on the design of a model which would be used to evaluate the flangeability of high-strength hot-rolled steel plate by simulation and optimization and the key technologies of flanging forming simulation. Then it brought out the evaluated index, summarized the influence of mould parameters, procedure parameters and material parameters. At last, the evaluated mould was developed and carried out validated experiments. By plenty of simulation, a “W”-shape model was brought out. The contour line of the die was assembled by two arcs with radius 30mm and central angle 900, an arc with radius 45mm and central angle 900 and two lines with 25mm long which were tangent with the three arcs. The width of b