基于pxi总线的虚拟仪器系统软件设计与实现-通信与信息系统专业论文.docxVIP

武汉理工大学硕士学位论文Abstract 武汉理工大学硕士学位论文 Abstract The Vmual Inslnnnent system has obtained the widespread approval and application in the world since the concgpt of Virtual Instrument was firstly proposed by National Instruments coporation in 1986．The powerful software of computer technology is gradually replaeeing the traditional instrument hardware．In order to adapt the various changes in instruments and auto testing domian,PXI expands PCI bus which has been defined by CompaetPCI to an electricity,machinery and soRware specification that is sutiable for testing，measurement and data acquisition． Combining the high performance of PC and low cost of PCI bus，the PXI modulars satisfy requirement of high performance，reliability,usability and economical efficiency on various platforms． This paper mainly discussed the software technology based-oll PXI platform． n圮authors main research work is as follows： (1)The concept of PXI system was introduced．The sofhvare and hardware specification of PXl were also presented．Then a software architecture 011 PXI palform was proposed． (2)The design and implemenfion of instrument drivers of PXI modulars：Now there are mainly 3 kinds ofmodels ofinstrument drivers．11 The PCI drivers ofWDM for PCI devices under Wmdows．2、The model of instrument drivers based on VISA which is defined by VPP．3)The model ofinstrument drivers which is defined b)r IVI foudation．In this part of the paper,all the 3 models were introduced firstly．Then a comparison of them was given from designing difficulties，functions and scope of application．Lastly,all instance of instrument drivers of PXI modular was given aecording to Actual need (3)The design and implemention of PXI system in programmable mode： According to the requirement of forming ATS and eompatibility晰th other buses．a design of IEEE488(GPIB)compatible instrument oil PXI platform was prposed．h this part of the paper,a sumey of IEEE-488 bus was given firstly,and then the Ⅱ 武汉理工大学硕士学位论文management 武汉理工大学硕士学位论文 managem