ISO 金属材料的焊接程序规范和合格鉴定.焊接程序试验.第部分 非合金和低合金铸铁的熔焊.docxVIP

STANDARD 15614-3 Firstedition 2008-03-15 Specification and qualification of welding procedures for metallic materials ! Welding procedure test ! Part3: Fusion welding of non-alloyed and low-alloyed cast irons Descriptif et qualification d’un mode op?ratoire de soudage pour les mat?riaux m?talliques ! épreuve de qualification d’un mode op?ratoire de soudage ! Partie 3: Soudage par fusion des fontes non alli?es et faiblement alli?es Reference number ISO 15614-3:2008(E) ISO 2008 PDF disclaimer This PDF file may contain embedded typefaces.In accordance with Adobe’s lcensing policy,this file may be printed orviewed but shalnotbe edited unless the typefaces which are embedded are licensed to and instaled on the computerperforming the editing.In downloading this file,parties accepttherein the responsibility ofnotinfrnging Adobe’s lcensing policy.The ISO CentralSecretariat accepts no lability in this area. Adobe is a trademark ofAdobe Systems Incorporated. Details ofthe software products used to creat this PDF file can be found in the GeneralInfo relative to the file;the PDF-creation parameters wer optmized forprinting.Every care has been taken to ensur thatthe file is suitable foruse by ISO memberbodies.In the unlikely eventthata problem relating to itis found,please inform the CentralSecretariatatthe address given below. COPYRIGHT PROTECTED DOCUMENT ISO 2008 Alrights reserved.Unless otherwise specified,no partofthis publication may be reproduced orutilized in any form orby any means, electronic ormechanical,including photocopying and microfilm,withoutpermission in writing from eitherISO atthe address below or ISO’s memberbody in the country ofthe requester. ISO copyrightoffice Case postale 56 ! CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@ W eb Published in Switzerland i ISO 2008 ! Alrights reserved 标准分享网 免费下载 Contents Page Foreword iv Introduction v 1 Scope 1 2 Normative references 1 3 Terms and definitions 2 4 Welding processes 3