基于fluent的旋流池数值模拟与优化研究-市政工程专业论文.docxVIP

英文摘要Rotational 英文摘要 Rotational flow sedimentation tank,aS a important method to purify waste water in metaIlu唱y indnstry,is designed to separate ferric oxide particles from backward cooling water,and the particles are deposited at the bottom cut．In its application,serious ferric oxide particles sedimentation phenomenon could often been found at suction well．This phenomenon will result in serious damage to the pump body and frequent cleaning toward ferric oxide particles，and will producc troubles to production and management． So its necessary to investigate this phenomenon deeply in the front stage．A new rotational flow sedimentation tank is set up by changing the structure in the tank and the inlet velocity,and the problem of ferric oxide particles sedimentation is solved completely．The new type tank is provided with higher separation function than the traditional rotational flow sedimentation tank． But a few message was found in the fast stage：the simulation parameters affect the simulation veracity obviously,the structure of the rotational flow sedimentation tank isn’t simplified by removing the suction well and fixing cone plank,the aperture of perforation plank and the inlet velocity also affect the deposition function of ferric oxide particles 0b“0IlSly．In this article，the simulation parameters and the structure parameters in the first stage will be taken further research．The content of the research are these aspects described as follows：optimization of the iteration number,sphericity coefficient，reflect coefficient,number of steps and length scale；the separation efficiency between fixing cone plank and removing cone plank are compared to decide whether removing the cone plank or not．the effect of deposition function in the case of changing aperture size and inlet velocity．In this article，turbulent flow model and dynamical particle dispersion model were used to set up the numerical fluid dynamical model of the rotational flow sedimentation tank．The preprocess m