通信车EMC软件交互建模与集成设计分析.pdfVIP

通信车 EMC 软件交互建模与集成设计研究 Abstract Abstract With the development of science and technology and various electronic devices being used widely, electromagnetic compatibility (EMC) issues are increasingly becoming a serious problem that must be taken into account about national defense, scientific research, production and life. Because of the development of computer technology, the popularity of computers and the mature technology of 2D, 3D graphics, simulating and analysing EMC performance of product in the preliminary design by EMC analysis software has become a trend. Based on the VC++ and OpenGL platform,this article makes an improvement on modeling ，model editor, electromagnetic calculation and post processing of the communication vehicle EMC analysis software. The research is as follows. 1. Since the modeling part of the original analysis software cannot achieve the function well of real-time display and dynamic response in the process of modeling and only build a wire antenna model, it is not perfect and not very good to meet the requirements of engineering. Therefore, on the basis of finishing surface element pickup and point capture, this article sets the triangle, quadrangle, cylindrical and conical geometry unit real-time and interactively.Besides, the angle reflector antenna and the paraboloid antenna model are built, too.The whole process of modeling with real time display reflects the real time, dynamic and visual design requirements of the interactive graphics software. 2. The electromagnetic calculation and post processing modules of the original software contain only the surface current, pattern, coupling and single antenna field calculation an