手部负重行走时人体表面肌电特征信号的研究-机械设计及理论专业论文.docxVIP

ABSTRACTIn ABSTRACT In the process of weight bearing walking，human muscles will get tired．Fatigue can cause muscle damage problems．Aimed at the working state of the human body muscle weight walking conditions were studied can obtain the state parameters of muscle activity, provides the reference basis for the rehabilitation training．Thus it is significant to make a research of muscle’S condition working for single arm hand weight bearing walking．In this paper,I mainly study research of the SEMG characteristics of the human body single arm walking hand load of upper limb and lower limb． This research collected the normal young people to carry the electromyographic signal by EMG acquisition system．Collected AEMG and MPF of walk don’t load and different load conditions．The quality of the test weight load respectively,of O％．of its weight，5％，1 0％，l 5％．Right arm was load weight and left arm wasn’t load weight． Subject tO the same speed walking 30 minutes．From moment，every 5minutes data acquisition，subjects every 1 0 m inutes subjective assessment．I adopt biceps brachii，triceps brachii，brachioradialis，extensor digitorum，bone rectus，biceps femoris muscles，tibialis anterior muscles，lateral gastrocnemius for measuring．According to the experiment get accurate evaluation index based SEMG AEMG and MPF eigenvalue， using SPSS statistical analysis software to standardize data processing，compared the methods of electrical characteristics between muscles． As analyzed above，it is concluded that the human body in different walking load of upper limb and lower limb muscle function had the differences between men and women． And with the increase of load，the more differences between men and women．Male on both side of upper limb muscle large difference did not exist bilateral symmetry,difference both sides of lower limbs muscle，bilateral symmetry．Female and male about symmetry was the same．；The human body upon completion of the single arm hand in the process of the different weight to wal