撞击接触—易拉.pptVIP

Workshop Goal and Procedure Goal: Crush an aluminum beverage can and allow it to “springback” Procedure: Create an Explicit Dynamics (ANSYS) Analysis System Project Select the units system and define the material properties Import, modify, and mesh the soda can geometry Define analysis settings, boundary conditions, and external loads Initiate the solution (AUTODYN - STR) and review the results Step 1 – Create the Project Schematic Start ANSYS Workbench and follow the sequenced steps using the abbreviations shown below: DC = Double Click with Left Mouse Button SC = Single Click with Left Mouse Button RMB = Right Mouse Button Selection DD = Drag and Drop = Hold Left Mouse Button down on item while dragging it to new location and then release it (i.e., Copy or Move) Step 2 – Specify the Project Units 2.a Select MKS for the Project Units from the Units List provided 2.b Request that Native Applications in Workbench have their values be Displayed in the Project Units 2.c Check those unit systems to Suppress from appearing in the Units List Step 3 – Define Engineering Data Material 3.a Edit the Engineering Data cell to add a material to the default library. 3.b Select the last slot under Engineering Data to define a new material model. Step 3 – Define Engineering Data Material ... 3.e Add the following Physical Properties to the material definition: Density Isotropic Elasticity Bilinear Isotropic Hardening Step 3 – Define Engineering Data Material ... 3.f Enter the following values: Density = 2710 kg m^-3 Young’s Modulus = 7e10 Pa Poisson’s Ratio = 0.30 Yield Strength = 2.9e8 Pa Tangent Modulus = 0.0 Pa Since the material is sufficiently defined, the blue question marks and yellow fields are no longer present in the data table. Note: The resulting stress-strain curve is elastic – perfectly plastic. No strain hardening can develop. Step 3 – Define Engineering Data Material ... 3.g Return to the Project Schematic 3.h Save the Project by selecti