PPAP—生产件批准程序(ppt).pptVIP

生产件批准程序Production part approval process 第四版 Fourth edition 黄建平 Jacky Huang 北京逖埃斯管理顾问有限公司 PPAP—生产件批准程序PPAP-Production part approval process 生产件批准程序（PPAP）定义了生产件批准的一般要求，包括生产件和散装材料（见术语）。 Production part approval process (PPAP) defines generic requirements for production part approval, including production and bulk material (see glossary). PPAP的目的是用来确定组织是否已经正确理解了顾客工程设计记录和规范的所有要求，以及该制造过程是否具有潜力，在实际生产运行中，依报价时的生产节拍，持续生产满足顾客要求的产品。 The purpose of PPAP is to determine if all customer engineering design record and specification requirements are properly understood by the organization and that the manufacturing process has the potential to produce product consistently meeting these requirements during an actual production run at the quoted production rate. 适用性Applicability PPAP必须适用于提供生产件、服务件、生产原料或散装材料的组织的内部和外部现场（见术语）。散装材料不要求PPAP，除非由经授权的顾客代表规定。 PPAP shall apply to internal and external organization sites supplying productions parts, service parts, productions material, or bulk material. For bulk materials, PPAP is not required unless specified by the authorize customer representative. 第一部分 总则Section 1 General 1.1 PPAP的提交 Submission PPAP 下列情况，组织必须获得经授权的顾客代表的批准： The organization shall obtain approval from the authorized customer representative for : 1. 一种新的零件或产品（即：以前未曾提供给某个顾客的某种零件、材料或颜色）。 A new part or product (e.g. a specific part, material, or color not previously supplied to the specific customer). 2. 对以前提交零件不符合的纠正。 Correction of a discrepancy on a previous submitted part. 3. 由于设计记录、规范或材料方面的工程变更从而引起产品的改变。 Product modified by an engineering change to design records, specifications, or materials,. 4. 第3部分要求中的任一种情况。 Any situation required by Section 3 注：任何有关生产件批准的问题，请与经授权的顾客代表联系。 Note: If there is any question concerning the need of production part approval, contact the authorized customer representative. 第二部分 PPAP的过程要求Section 2 PPAP process requirements 2.1 有效的生产 Significant Production Run 对于生产件,用于PPAP的产品,必须取自有效的生产。该生产过程必须是1小时到8小时的量产，且规定的生产数