断电对岩土热响应测试影响的研究供热供燃气通风及空调工程专业论文.docxVIP

  • 3
  • 0
  • 约5.24万字
  • 约 59页
  • 2019-01-30 发布于上海
  • 举报

断电对岩土热响应测试影响的研究供热供燃气通风及空调工程专业论文.docx

断电对岩土热响应测试影响的研究供热供燃气通风及空调工程专业论文

断f乜对岩土热响应测试影响的研究摘 断f乜对岩土热响应测试影响的研究 摘 要 钻凿换热孔和铺设U型地埋管的费用在整个地埋管地源热泵系统的投资中约 占三分之一的比例,直接影响到地源热泵系统的成本。而岩土导热系数是地埋管 设计的重要基础参数。当岩土导热系数发生10%的偏差时,地埋管的设计长度将 偏差4.5%一5.8%,所以导热系数的准确与否直接影响到地源热泵系统的初投资。 而体积热容量则对系统的运行,尤其是变负荷情况下运行有非常大的影响。因此 本文探讨了热响应测试过程中起始加热时间、断电时间以及孔径等各个参数分别 对岩土导热系数和体积热容量的影响,以期能在热响应测试中得到更为准确的岩 土热物性参数。 ASHRAE手册中规定在已经进行了完整的48小时测试的情况下,如果需要 重新进行测试,则需要等U型管回路中的温度回复到与初始温度的差值不大于 0.3K方可进行。对于中等或高导热率(A苫1.7 W/m·K)的地层,这一过程需要10~12 天,而对于低导热率(A1.7 W/m·K)的地层,则需要等待14天。如果已经进行的 测试时间较短,则等待时间可以相应地缩短。本文通过编程计算了不同孔径,高、 中、低热导率的地层在分别已经进行了1—36小时测试的情况,由于停电导致测 试中断,重新进行测试时所需要的等待时间。 本文在已建立的变功率钻孔内与周围岩土的换热模型基础上,结合参数估计 的方法,通过编程计算得到在变功率情况下的岩土热物性参数,并通过实验验证 了该方法的正确性。研究结果表明,该方法能显著降低热响应测试对加热功率稳 定性的要求,更适用于工程实际。 研究结果得出不同孔径,高、中、低热导率的地层在分别已经进行了1—36 小时测试的情况,由于停电导致测试中断,重新进行测试时所需要的等待时间。 同时得出变功率下计算岩土热物性的方法。 关键词:热响应测试;导热系数;体积热容量;等待时间;变加热功率 硕I:学位论文Abstra 硕I:学位论文 Abstra ct The cost of boring heat-transfer hole and paving U-type buried pipes will account for one third of the ground·source heat pump system.So,it has been one restraining factor in the system development.Whereas the thermal conductivity of rock·soil is an important basic parameter of the design of the ground heat exchanger. And there will be 4.5-5.8%deviation on the design length of the ground heat exchanger if it has 10%offset of the thermal conductivity.Therefore,it directly impacts the initial cost of the ground source heat pump system that whether the thermal conductivity is accurate or not.At the same time,the volumetric heat capacity affects the work,especially the change of operating conditions,of the ground source heat pump system.Therefore,to get more accurate parameters of the thermo·physical properties of rock—soil,this paper researches the influence of starting heat time,time of power off and bore diameter on the thermal conductivity and the volumetric heat capacity of rock-soil in the Thermal Response Test. In ASHRAE handbook,it is ruled that it is needed to wait that the temperature difference between the U-type circuit and the initial gro

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档