基于DSP的Z源逆变器控制与设计-电力电子与电力传动专业论文.docxVIP

Control Control and Design for Z-Source Inverter Based on DSP Abstract Inverter,鹊all important part of new energy generation system such as wind energy,solar energy， fuel cell ere，plays a key role in the c93ui-se of energy conversion and transmission．The traditional inverter ineludes voltage source inverter(vso and current source inverter(cso．However,both ofthe invcrters have barriers and limitations． They are either a buck(VSl)or a boost(cso inverter,In order to require a higher voltage or lower voltage relative to input voltage，an additional DC-DC converter to boost the output voltage(vSO or to buck the output voltage(csi)is needed，which lowers the efficiency of system．What i8 more，in a traditional inverter,the upper and lower devices of each phase leg could be gated ON(or OFF) simultaneously bv EMI noise．which would decrease the circuit reliability．To avoid the state。dead time has to be provided in the control strategy．Nevertheless，a disadvantage of the dead time is that it can bring the output voltage and current waveform distortion． In ordelto solve the above limitations oftraditional inverter,a new type inverter named乙source inverter WaS presented．which Can overcome the drawbacks of the traditional inverter；it employs a unique impedance network(Z-network),which elllOWS the Z—source inverter to have some new features Which are disabled on traditional inverter． In this paper,the operating principle and superiority of the Z-source inverter are described firstly,And its mathematical modeI and PWM control strategy are analyzed in detail．Then the deviceS voltage and current stress iS analyzed，Whieh offers a thcoretical authority to the control of二SOUrce inverter based Off DS P．At the same time,the design method of乙source inverter is given out．Finally two sets of 7-．SOUrce inverter systems are built under grid-connected active power inversion and UPS passive power inversion．the simulation and experimental results have been performed to confirm the analysis．They are