基于OBd-Ⅱ的通信控制与应用开发-电子与通信工程专业论文.docxVIP

广西师范大学硕士毕业论文of 广西师范大学硕士毕业论文 of OBD modules used STM32 as main control chip，the main design work of OBD module are as follows：USB circuit，data transceiver circuit of CAN，transceiver circuit of K line and circuit of power supply and SO on．Depict the PCB after finishing the design of circuits and make it into board，then weld it to undertake the whole design of hardware．Thirdly,write the programs of software which is made up of two main sections，the programming of OBD module-driven and the communication of diagnosis system and Bluetooth，the design for the upper workstation software of Android：the UI interface，the Bluetooth communication program of Android mobile phone，the voice recognition program and SO on．Finally，test the whole design through testing the communication of the individual protocols are successful or not and the connection of mobile phone and OBD module SO as to get the information of the simulator．Voice recognition can be divided into cloud telephony and local voice，respectively test the recognition rate and analyze the merits and demerits．The field test has been done after the simulator test，which can verify the correctness of the OBD module design，whether the automobile data Can be read into the mobile phone or not，and whether the automobile Can be controlled simply by mobile phone． Key words：On-board Diagnostics；scanning tunneling microscope；Android；diagnostic protocol； electronic control unit；Voice Contr01． III 万方数据 广西师范大学硕士毕业论文目录 广西师范大学硕士毕业论文 目录 摘要 I Abstract． ． ． ． ． ． ．． ． ． ． ． ． ． ． ．．．I】[ 第一章绪论 ．．1 1．1引言 ．．1 1．2 OBD简介 ．1 1．2．1为什么需要OBD 1 1．2．2 OBD的工作方式 1 1．2．3 OBD系统的诊断功能 2 1．2．4 OBD系统的组成 2 1．3 OBD国内外发展背景及现状 ．．3 1．3．1 OBD的诞生 ．3 1．3．2 OBD相关法律规定 4 1．3．3国内外现状 ．5 1．4标准化OBD系统 ．5 1．4．1 OBD接口 5 I．4．2标准通信协议 ．．6 1．4．3标准故障码 ．．6 1．5论文研究的主要内容 7 1．6论文的结构 ．8 第二章OBD主要协议研究 9 2．1 KWP2000 9 2．1．1初始化和定时参数 9 2．1．2报文结构 10 2．1．3应答解析 1 1 2，1．4通信服务 12 2．1．5诊断及数据传输 ．．12 2．2协议具体的读写机制 ． 16 2．2．1协议IOSl5765-4 16 2．2．2协议IS014230-4 17 2．2．3协议IS09141．2 17 第三章OBD模块硬件电路设计 ． 19 3．