基于等效压缩变形的固态焊接技术-材料物理与化学专业论文.docxVIP

河南科技大学硕士学位论文条件下也可实现基于EPCD的固态焊接，接头焊合率可达88％以 河南科技大学硕士学位论文 条件下也可实现基于EPCD的固态焊接，接头焊合率可达88％以 上。 这种基于等效压缩变形的固态焊接技术可以使现有固态焊接技 术工艺及设备大大简化，焊接变形容易控制而更易实现精密连接，更 利于工业应用，在许多情况下可以代替现有连接技术而有较好的应用 前景。本研究对固态连接技术的开发提供了理论和试验依据，具有一 定的理论和工程应用价值。 关键词：等效压缩变形，固态焊接，激光淬火，夹层，钢，钛合金 II 摘要Technique 摘要 Technique of Solid—State Welding B ased on Equivalent Plastic Compressive Deformation ABSTRACT During many technical P rocesses of solid—state welding，specimen const rained will ．3roduce co rresponding plastic compressive defo rmation in the heating P Focess(in the elevating and keeping temperature p rocess)，fo r expansive defo rmation is hindered in the direction of const rain：：ng．This defo rmation also plays an identical role in the fo rming of J o 12：．which is likely extrusion forging in pressu re welding， SO it ca．q be called Equivalent Plastic Comp ressive Deformation(EPCD)．This compressive defo rmation is universally exist in the process of solid-state welding，but the function in the fo rming of Joint is often omitted，not even cont rolled and utilized． The study indicates that in many p rocesses of solid—state welding， the solid-state welding will may be achieved in the heating process of solid-state welding，cont rolling the factors of influencing EPCD， making EPCD react．1arge enough tO meet the required plastic comp ressive defo rmation formed Joints．To explore the feasibility of the solid-state welding based on EPCD，taking 40Cr，TIOA，TC4，TA2 as the object to studY in this pape r，an expe rimental study was carried out by the solid—state welding based on EPCD．The effect of three mainly technological facto rs which contain welding temperature， prepressure，heat prese rvation time，and the state of surface for welding face，inte rlayer and SO on is discussed emphasis．The majo r or secondary factors of Ehe effect on the tensile strength of the Joint and the specimen defo rmation and the supe rior level are analyzed by Ill 河南科技大学硕士学位论文ove 河南科