基于超音速电弧喷涂技术的参数优化及防腐蚀涂层研究-材料加工工程专业论文.docxVIP

Abs仃actIn Abs仃act In this paper，theoretical analysis is conducted on the principle of arc spraying process，based on the current state and development of arc spraying technology at home and aboard．Mathematical model of air-mileage is created through studying droplet dynamics on arc spraying processERNiCu-7 coating is produced by supersonic velocity electric arc spraying technology on the chemical reactor． Optimum process parameters optimized by orthogonal experimental design are acquired following the principle of arc spraying process．Combination mechanism and corrosion resistant mechanism ofAl，Zn，316 non-corrosive steel and ERNiCu一7 comings prepared by arc spraying process are studied，which provides the theoretical basis for the extensive application ofthe process optimized and coatings with corrosion resistance． The different matching level ofthe spraying craft parameter combines the influence of the intensity，hardness，hole rate on the coating differently，SO obtained the combined intensity，high hardness and low hole rate ofthe coating，the matching ofevery factor level is different． Using electrochemical workstation measurg the steady polarizationg curves and Tafel slope of supersonic arc apray coating AI，Zn，316 non—corrosive steel and ERNiCu-7 in HzS04 solution of 60 percent．The microstructure is investigated by metallographic microscope and X—ray diffraction before and after corrosion．ERNiCu-7 among the four coating is the most proper material to spray． Key words：supersonic arc spray，chemical reactor，ERNiCu-7，orthogonal test, Tafel slope 独创性声明本人声明所呈交的论文是我个人在导师指导下进行的研究工作及取得的研究成果。 独创性声明 本人声明所呈交的论文是我个人在导师指导下进行的研究工作及取得的研究成果。 尽我所知，除了文中特别加以标注和致谢的地方外，论文中不包含其他人已经发表或撰 写过的研究成果，也不包含为获得山东理工大学或其它教育机构的学位或证书而使用过 的材料。与我一同工作的同志对本研究所做的任何贡献均已在论文中作了明确的说明并 表示了谢意。 一签彬水 时间：刀刃年6月l一日 关于论文使用授权的说明 本人完全了解山东理工大学有关保留、使用学位论文的规定，即：学校有权保留送 交论文的复印件和磁盘，允许论文被查阅和借阅；学校可以用不同方式在不同媒体上发 表、传播学位论文的全部或部分内容，可以采用影印、缩印或扫描等复制手段保存、汇 编学位论文。 (保密的学位论文在解密后应遵守此协议) 研究生签 时间≯引年6月，口日 导师签 时间：埘年5月一日 山东理工大学硕{J学位论文 山东理工大学硕{J