51单片机流水灯、数码管、定时器、秒表、计算器程序.docVIP

. .. 流水灯 #includereg52.h char data_group[]={0x7e,0xbd,0xdb,0xe7,0xdb,0xbd,0x7e}; unsigned int a; void delay(unsigned int time) { int i,j; for(i=time;i0;i--){ for(j=100;j0;j--); } } void move_mid_side(void) { int m; for(m=0;m7;m++){ P1=data_group[m]; delay(500); } } void move_right_only(void) { int a,temp; delay(500); temp=0x80; for(a=7;a=0;a--){ temp=~temp; P1=temp; delay(500); temp=~temp; temp=1; } temp=0x80; delay(1000); } void move_left_only(void) { int a,temp; delay(500); temp=0x01; for(a=7;a=0;a--){ temp=~temp; P1=temp; delay(500); temp=~temp; temp=1; } temp=0x01; delay(1000); } void move_right_hlod(void) { int a,temp; temp=0x7f; for(a=8;a=0;a--){ P1=temp; delay(500); temp=temp1; } temp=~temp; delay(1000); } void move_left_hold(void) { int a,temp; temp=0xfe; for(a=8;a=0;a--){ P1=temp; delay(500); temp=1; } temp=~temp; delay(1000); } void main() { while(1) { move_left_hold(); move_mid_side(); move_right_hlod(); move_mid_side(); move_left_only(); move_right_only(); } } 数码管 #include reg52.h char data_duan[]={0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90};//0~9 char data_wei[]={0xff,0x7f,0xbf,0xdf,0xef,0xf7,0xfb,0xfd,0xfe,0x00}; //0xff全关，之后为第一个数码管到第八个数码管 //char data_wei_add[]={0x7f,0x3f,0x1f,0x0f,0x07,0x03,0x01,0x00}; void delay(unsigned int time) { int i,j; for(i=time;i0;i--){ for(j=0;j100;j++); } } void show_number_only(void) { int i; P2=data_wei[1]; //P2为位选 for(i=0;i10;i++){ P0=data_duan[i]; //P0为段选 delay(500); } } /*******************数码管动态显示子程序***************/ void move_show1(void) { int i; for(i=1;i2;i++){ P2=data_wei[i]; P0=data_duan[i]; delay(1); } } void move_show2(void) { int i; for(i=1;i3;i++){ P2=data_wei[i]; P0=data_duan[i]; delay(1); } } void move_show3(void) { int i; for(i=1;i4;i++){ P2=data_wei[i]; P0=data_duan[i]; delay(1); } } void move_show4(void) { int i; for(i=0;i5;i++){ P