板形标准曲线的理论计算方法-机械工程学报.PDF

第 44 卷第 8 期 机 械 工 程 学 报 Vol.44 No. 8 2008 年 8 月 CHINESE JOURNAL OF MECHANICAL ENGINEERING Aug. 2008 DOI ：10.3901/JME.2008.08.137 板形标准曲线的理论计算方法* 1 1 1 2 刘宏民 丁开荣 李兴东 江光彪 (1. 燕山大学轧制设备及成套技术教育部工程研究中心 秦皇岛 066004 ； 2. 宝山钢铁股份有限公司宝钢分公司 上海 200941) 摘要：联立板形预报模型和板形判别模型，提出板带轧机板形标准曲线的理论计算方法。该理论计算方法的思路和原则是最 大限度地消除板凸度并同时兼顾板形良好，最终使板形趋于最好，这种计算方法的目标是实现板形和板凸度的综合最优控制。 以 1 220 mm 五机架带钢冷连轧机和 900 mm 单机架带钢冷轧机 5 道次轧制为例，分别对轧制中凸板和中凹板的情况进行计 算，计算结果证实了理论分析计算的正确性。这种板形标准曲线的理论计算方法为进一步从理论上定量研究板形标准曲线模 型奠定了良好的理论基础。 关键词：板带轧制 板形 凸度 板形标准曲线 板形预报 板形判别 条元法 中图分类号：TG333 Theoretical Computational Method of Shape Standard Curve LIU Hongmin1 DING Kairong1 LI Xingdong1 JIANG Guangbiao2 (1. Engineering Research Center of Rolling Equipment and Complete Technology of Ministry of Education, Yanshan University, Qinhuangdao 066004; 2. Baosteel Branch, Baoshan Iron Steel Co. Ltd., Shanghai 200941) Abstract: The theoretical computational method of the shape standard curve of strip mills is proposed by using the shape forecast model and the shape discrimination model. The idea or principle of this method is that the strip crown is eliminated furthest, the good shape is obtained simultaneously and the final pass shape closes to the best also, the whole aim is the realization of the comprehensive optimum control of shape and crown. Taking 1 220 mm five-stand cold strip rolling tandem mills and five-pass rolling of 900 mm single stand cold strip rolling mill as examples, the rolling computations of convex strip and concave strip are done respectively, the computational results prove the validity of the