基于图像处理的麻花钻头修磨角自动定位设计-检测技术与自动化装置专业论文.docxVIP

Ab Abstract PAGE PAGE VI variance. Then, it strikes the ramp minimum bounding rectangle of the drill tip’s edge. It can find the general area position of the main cutting edge with this rectangle and find the edge point of the main cutting edge by using the Hough transform. Lastly, it uses the straight-line fit to fit the drill straight edge equations and obtains the drill’s original corner through these equations. Experimental tests show that this system can automatically locate the grinding angle of the drill exactly. It is stable and has small errors in its work, and has a good practical value. It also lays a solid theoretical and technical basis for realizing the development of automatic repairing drill grinding device. Keywords: Twist Drill; Angular Positioning; Image Processing; Motor Control; Auto focus 目 目 录 目 录 摘 要 ······································································································································ I Abstract··································································································································II 第一章 绪论 ························································································································· 1 §1.1 引言 ······················································································································· 1 §1.2 国内外研究现状 ··································································································· 1 §1.2.1 麻花钻头刃磨研究现状 ············································································· 1 §1.2.2 数字图像处理概述 ····················································································· 2 §1.3 本文的主要工作及论文安排 ··············································································· 4 第二章 麻花钻头介绍 ········································································································· 5 §2.1 麻花钻头概述 ············································