基于DOST能量相似度的有源配电网故障.docxVIP

基于DOST能量相似度的有源配电网故障 区间定位方法 李卫国，王旭光，卢广旗，许文文 （东北电力大学电气工程学院,吉林 吉林 132012） 摘要：有源配电网小电流接地系统发生单相接地短路时，通过理论分析得出单个DG接入配电网并不影响零序电流大小的结论，由此提出一种基于离散正交S变换（DOST）暂态零序电流能量相似度的故障定位方法。首先对线路上检测设备上传的暂态零序电流信号进行离散正交S变换，然后利用得到的时频矩阵中的元素计算线路区间两端检测点的能量相似度，能量相似度小于设定的阈值即为故障区间。Matlab/Simulink仿真结果表明该方法准确有效，适用于有源配电网的故障区间定位。 关键词：有源配电网；故障区间定位；离散正交S变换；能量相似度 中图分类号：TM93 文献标识码：A 文章编号：1001-1390（2019）00-0000-00 A fault section location method for active distribution network based on discrete orthogonal S-transform and energy similarity Li Weiguo, Wang Xuguang, Lu Guangqi, Xu Wenwen (School of Electrical Engineering, Northeast Electric Power University,JilinUniversity, Jilin 132012, Jilin，, chinaChina) Abstract:WhenAbstract: When the single-phase to ground short-circuit occurs in the small-current grounding system of the active distribution network, through the theoretical analysis of shows that the single DG access to distribution network does not affect the zero zero-sequence current conclusion, so a discrete orthogonal S-Transform transform (DOST) Fault fault location method of zero zero-sequence current energy similarity was proposed in this paper. Firstly, the discrete orthogonal S S-transform is applied to the transient zero sequence current signal uploaded by the detection equipment on the line, and then, the energy similarity of detection points at both ends of the line section is calculated by using the data in the time-frequency matrix obtained, the energy similarity is less than the setting The threshold, which is called is the fault interval. The simulation results of Matlab / Simulink show that the proposed method is accurate and effective and can be applied to the fault zone location of active distribution network. Keywords：active distribution network,faultnetwork, fault section location,discretelocation, discrete orthogonal S-transform,energytransform, energy similarity 0 引言 我国6-35 kV的配电网中性点普遍采用小电流接地系统，在小电流接地系统的各种故障类型中，单相接地故障的发生概率高达80%[1]，发生故障时虽然能够继续运行0.5-2h，但如果不及时处理，对电网