格浴格慥琼莹敬举剅琯莹敬栯慥瑨汭áā开.DOC

???ˇ±á?˙ _a?˙˙˙^˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙˙ě?á ???8bjbj?? R?j?j}4[˙˙˙˙˙˙l????????bbb8??D?.Dě(... ?CμCμCμCμCμCμCE :G?μC? μCM ??..??C(M M M ?.?.?CM ?CM M Y%??4j???C.ú?úHiYX???b?C(?C$ňC.DgC(ňG5ňG?CM ???????Data Dictionary for Electric System Security Data Introduction The data and terms described here are intended as a definition and clarification of the electric system security data listed in Appendix 4B-A of NERC Policy 4B, System Coordination – Operational Security Information. Each term is defined and its current or expected method of exchange is specified. A number of additional security data types that would be useful to security coordinators and control areas are also identified, although they have not been defined. Issues and Limitations Some systems are incapable of sending derived data, or using derived data from other systems. It is assumed that Ampere measurements are used only for thermal limits calculations, and therefore, only an absolute value is required. In some cases, MVAR Gross Output is measured rather than MVAR Net Output. Either value is usable provided the actual data type is known by the receiver. There are a number of data types in existence today that did not exist when the original data types were defined (e.g. retail items). These are not included in this data dictionary. The only reference in NERC documentation to the direction that is to be assigned to negative and positive flows is in the Area Interchange Error Survey Training Document. This document specifies that net power into a control area is to be entered into the survey as a negative