红外热成像技术在金属氧化物避雷器缺陷检测中的应用-内蒙古电力技术.PDF

内蒙古电力技术 84 INNERMONGOLIAELECTRICPOWER 2015年第33卷第2期 doi:10.3969/j.issn.1008-6218.2015.02.014 红外热成像技术在金属氧化物避雷器缺陷检测中的应用 田晓云，岳永刚，范永强 （内蒙古超高压供电局，呼和浩特 010080） 摘要：在对某500kV变电站红外测温巡查时发现2号主变压器500kV侧金属氧化物避雷 器V相温度偏高，随即对该组避雷器进行运行中持续电流检测、1mA直流电流条件下电压 U 检测、0.75倍U 条件下泄漏电流测量，试验数据超标，推断该避雷器电阻片故障。将避 1mA 1mA 雷器返厂进行拆解、试验，发现故障原因为内部受潮，局部闪络，导致绝缘电阻下降。实例证 明了红外热成像技术能快速、有效地发现该类故障，是诊断金属氧化物避雷器故障的有效手 段之一。 关键词：金属氧化物避雷器；红外热成像；缺陷；受潮；泄漏电流 文献标志码：B 中图分类号：TN219 文章编号：1008－6218（2015）02－0084－04 Applicationof InfraredThermal Imaging Technology in Metal Oxide Arrestor Defect Detect TIAN Xiaoyun,YUEYonggang, FANYongqiang （Inner Mongolia Extra-high Voltage Power Supply Bureau,Hohhot 010080,China） Abstract：In some 500 kV substation, the infrared temperature detect that V-phase metal oxide arrester(MOA) of the No.2 main transformer in the side of 500kV was in over temperature, then took measuring test of persistent current detection, the voltage of U1mA under 1mA DC current and leakage current under 75%U . The test data was exceeded, 1mA by which further verified the arrester resistance fault. Then back to factory for the dismantling and experiment, discovered the cause of failure was internal moisture, local flashover, resulting in insulation resistance drop. And proved that the infrared thermal imaging technology could quickly and effectively discover such an accident, and it was an effectivemethodin diagnosisofmetal oxidearrestermalfunction. Key words：metal oxide arrestor; infrared thermal imaging; defect; moistur