外企模具检查清单-英文版Mold test checklist.docVIP

Luxembourg Technical Center FS-02V5e page PAGE 1/5 Contact?: B. Jeanjot (+352 52 115 4372) Mold test checklist (press the tab key to fill-in the different fields) General information Company name: FORMTEXT Address: FORMTEXT FORMTEXT Contact person: FORMTEXT Phone number: FORMTEXT Fax number: FORMTEXT E-mail address: FORMTEXT Mold delivery date: FORMTEXT Mold return date: FORMTEXT Carrier: FORMTEXT (Name phone n°) Test’s target Short description (part quality, cycle time to be achieved, clamp tonnage reduction, etc…): FORMTEXT Process information Specification of the machine presently used with this mold: FORMTEXT Actual cycle time: FORMTEXT Required cycle time: FORMTEXT Actual cooling time: FORMTEXT Injection time: FORMTEXT Hold time: FORMTEXT Recovery time: FORMTEXT Plasticizing rate (g/s): FORMTEXT Moving side cooling water: T°: FORMTEXT Flow: FORMTEXT Bar: FORMTEXT Stationary side cooling water: T°: FORMTEXT Flow: FORMTEXT Bar: FORMTEXT  Mold information Mold maker: FORMTEXT Mold type: Stack mold FORMCHECKBOX Standard mold (2 platens) FORMCHECKBOX If stack mold, please specify section dimension of the sprue bar: FORMTEXT Mold mounting pattern: Clamps FORMCHECKBOX Euromap (screw) FORMCHECKBOX Minimum stroke for free drop: FORMTEXT Mold size: Height (L): FORMTEXT mm Width (B): FORMTEXT mm Shutheight HR+HL: FORMTEXT mm Weight: FORMTEXT Kg Locating ring diameter: Moving platen: FORMTEXT Stationary platen: FORMTEXT Locating ring thickness: Moving platen: FORMTEXT Stationary platen: FORMTEXT Are both locating rings removable Yes FORMCHECKBOX NO FORMCHECKBOX Mold cooling information Quantity of cooling circuit: Moving platen: FORMTEXT Stationary platen: FORMTEXT Water fitting: DME FORMCHECKBOX Hasco FORMCHECKBOX Staubli FORMCHECKBOX Other FORMCHECKBOX Water fitting size: FORMTEXT  Mold information Ejector information Is the machine ejector used: