SPECIFICATION FOR STRUCTURAL FABRICATION 船舶 技术 规格书.doc

LD27-2/32-2-SPC-GEN-ST-0003CNOOC ENGINEERING LD27-2/32-2-SPC-GEN-ST-0003 CNOOC ENGINEERING SPECIFICATION FORSTRUCTURAL FABRICATION SPECIFICATION FOR STRUCTURAL FABRICATION PAGE PAGE \* MERGEFORMAT 4 Of NUMPAGES \* MERGEFORMAT 16 DETAIL DESIGN OF LD27-2/32-2 OIL FIELD DEVELOPMENT PROJECT JOB NO：08DD06 COSIGN DISCIPLINE SIGNATURE DATE STRUCTURE PAGE PAGE \* MERGEFORMAT 1 OF 16 B1 08.5.7 ISSUED FOR COMMENTS REV. DATE DESCRIPTION BY CH ‘K. REV’ W. EXAM. APPRO. CLIENT SPECIFICATION FOR STRUCTURAL FABRICATION OFFSHORE OIL ENGINEERING CO.,LTD. CNOOC Ltd. DOCUMENT NO. REV. CERTIFI. NO. LD27-2/32-2-SPC-GEN-ST-0003 B1 020017-sj CONTENTS TOC \o 1-2 \h \z \t 标题 9,9 1 INTRODUCTION h 3 1.1 Preamble h 3 1.2 Scope h 3 1.3 Codes, Standards and Specifications h 3 1.4 Documentation h 4 1.5 Performance of the Work h 5 1.6 Errors and Omissions h 6 2 MATERIALS h 6 2.1 General h 6 2.2 Material Control h 6 2.3 Material Storage and Handling h 7 3 GENERAL STRUCTURAL WELDING REQUIREMENTS h 7 4 FABRICATION AND CONSTRUCTION h 7 4.1 General h 7 4.2 Fabrication Sequences h 8 4.3 Preliminary Preparation of Base Material h 9 4.4 Forming of Plates into Tubule h 9 4.5 Preparation and Fit-up h 9 4.6 Temporary welded Attachments h 10 4.7 Splices-General h 10 4.8 Rolled and Built-up Structural Section Splices h 10 4.9 Structural Tubular Splices h 11 4.10 Proximity of Welded Seams h 11 4.11 Cut-Outs, Manholes and Cope Holes h 11 4.12 Lifting Attachments h 11 4.13 Site Assembly h 12 4.14 Bolted Connections h 12 4.15 Galvanized Steel h 13 4.16 Dimensional Tolerances h 13 4.17 Welded Plate Girders Requirements for Construction h 16  INTRODUCTION Preamble This specification defines minimum requirement that the jacket and deck structures and associated works required for the implementation for oil field surface facilities shall be fabricated in the most economic manner with due consideration of Intern