螺旋锥齿轮在机测量系统的研究-机械制造及其自动化专业毕业论文.docxVIP

西安理 西安理工大学硕士学位论文 II II Abstract Title: RESEARCH ON ON-MACHINE MEASURING SYSTEM OF SPIRAL BEVEL AND HYPOID GEAR Major: Mechanical Manufacturing and Automation Name: Sen Liu Signature: 元1 均 Supervisor: Prof. Feng Ga。 Abstract  Signature:有 (如 Spiral bevel and hypoid ge町S 町e important parts movement transmission and a dynamic in mechanical transmission system，which can transmit between two intersecting axis or two staggered sha位， it makes the spiral bevel ge缸s in the transmission with high bearing capacity， high contact ratio，smooth transmission ，low noise，and many otheradvantages ，thus has been widely applied. At present，along with numerical control technology，the rapid development of computer and measurement technology，in view of the spiral bevel ge町 tooth surface measurement ，the traditional way of contact p刷em detection began to change to the test of the geometry structure of the tooth surface. Foreign technology and measurement system have been quite mature，but the measuring equipment is expensive，and the technology blockaded. The study of spiral bevel ge町 on-machine measurement system to improve the quali句T ofthe products of gear manufacturing enterprises in China， enhance the intemational competitiveness of Chinas gear products has very important significance. The main works are as follows: The categories and characteristics of the Spiral bevel and hypoid ge缸 were surnmarized ，compared several methods of spiral bevel gear tooth surface modeling ，and have carried on the brief analysis and comparison. Established Spiral bevel and hypoid ge缸 tooth surface equation which is based on the forming principle of spherical involute tooth profile， and through the PRO? 3D so仕ware for solid modeling ，obtained measure index of the accuracy of Spiral bevel and hypoid gears，which lay the foundation for the determination of meas町ement of spiral bevel ge盯seηor inthe machine plan and measurement of each erro卫 Analyzed integral structure of the five ax