AT89C51 In-Circuit Programming 在电路编程中的应用.pdfVIP

AT89C51 In-Circuit Programming This application note illustrates the in-cir- During programming, AT89C51 I/O ports 8-Bit cuit programmability of the Atmel are used for the application of mode AT89C51 Flash-based microcontroller. select, addresses and data, possibly Microcontroller Guidelines for the addition of in-circuit requiring that the controller be isolated programmability to AT89C51 applica- from the application circuitry. How this is with Flash tions are presented along with an appli- done is application dependent and will cation example and the modifications to be addressed here only in general it required to support in-circuit program- terms. ming. A method is then shown by which the AT89C51 microcontroller in the Port Used for Input Application During programming, the controller must application can be reprogrammed be isolated from signals sourced by the Note remotely, over a commercial telephone application circuitry. A buffer with three- line. The circuitry described in this appli- state outputs might be inserted between cation note supports five volt program- the application circuitry and the control- ming only, requiring the use of an ler, with the buffer outputs three-stated AT89C51-XX-5. The standard AT89C51 when programming is enabled. Alter- requires 12 volts for programming. nately, a multiplexer might be used to The software for this application may