Humid Heat Cyclic (HHC)湿热循环相关.doc

Humid Heat Cyclic (HHC)湿热循环 Purpose:Verify the sample degradation effect at high temperature,humidity and low temperature accelerate environment. 目的：系决定试件在高温、湿度与低温加速环境下之退化效应。 Applicable standard: GMW3172Sec9.4.5 and IEC 60068-2-38-Z/AD 适用标准： GMW3172Sec9.4.5和IEC 60068-2-38-Z/AD Operation style: 2.1/3.2 操作类型：2.1/3.2 Procedure:过程： ONE:Temperature humidity cycle test with low temperature 一、含低温之温湿度循环试验 1.Chamber temperature should raising to 65±2℃ within 1.5～2.5h,keep relative humidity at 93±3%. 1. 温度柜中之温度应在1.5～2.5小时内持续升至65±2℃，相对湿度维持在93±3%。 2.Keep chamber temperature at 65±2℃,relative humidity at 93±3% until the 5.5 h. 2.温度柜中之温度应维持在65±2℃，相对湿度维持在93±3%，直到第5.5小时。 3.Lower the chamber temperature to 25±2℃ within 1.5～2.5h,relative humidity maintained at 80～96% until reached the 8 th hour. 3.温度柜中之温度应在1.5～2.5小时内持续下降至25±2℃，相对湿度需维持在80～96%之间，直到第8小时。 4.From the 8 th hour, raising the chamber temperature to 65±2℃ within 1.5～2.5,maintain relative humidity at 93±3%. 4.自第8小时起，温度柜中之温度应在1.5～2.5小时内持续升至65±2℃，相对湿度维持在93±3%. 5.Maintain chamber temperature at 65±2℃ and relative humidity at 93±3% until reached the 13.5 th hour. 5.温度柜中之温度应维持在65±2℃，相对湿度维持在93±3%，直到第13.5小时。 6.Lower the chamber temperature to 25±2℃ within 1.5～2.5h, maintain relative humidity at 80～96%. 6.温度柜中之温度应在1.5～2.5小时内持续下降至25±2℃，相对湿度需维持在80～96%之间。 7.Maintain the chamber temperature at 25±2℃ and relative humidity at 93±3%for at least 1h but no more than 2h. 7.温度柜中温度维持在25±2℃，相对湿度93±3%，至少1小时但不得超过2小时。 8.Operate low temperature for sample at the original chamber or removing to other chamber. Removing to other chamber should be done within 5 min.From the 17.5h,lower the temperature to -10±2℃.Reach this value before the 18 th hour. 8.试件可于原柜中进行低温试验或转移至他柜执行，若转移他柜须于五分钟内完成，自第17.5小时起，柜温应下降至-10±2℃，第18小时应到达此温度。 9.Maintain the above temperature for 3h. Don’t need to control relative humidity. 9.上述温度维持3小时，且不需控制相对湿度。 10.From the 21 th hour, raise the chamber temperature to 25±2℃. Reach this value before the 22.5 th hour. Removing to ot