AutoPIPE-StressISO-应力轴测图教程.docxVIP

Alias StressISO Troubleshooting Tips for AutoPIPE 09.06.01.xx and Lower Comments, Questions, and Answers with AutoPIPE StressISO (Alias). In addtion to the StressISO_Troubleshooting.pdf document found on your hard drive, see the following information:? Isogen is a 3rd party software that is bundles with many cad applications such as Bentley AutoPIPE to automatically produce an isometric drawing. Isogen is very particular about the format of the data being converted into an DXF, DWG, or DGN file format. If there is one error in the data Isogen may hang, display a message about warnings with the file, etc... Use the following steps to troubleshoot an Isogen related issue with AutoPIPE: 1. Known issues Known issues are documented in the StressISO_Troubleshooting.pdf located in the AutoPIPE folder. Review this document to see if it is a known issue. 2. Isometric based on actual pipe components: For an example, AutoPIPE can model a tee where the branch axis matches the same direction as the tees header pipe axis. This is wrong modeling but can be done in AutoPIPE. However, Isogen will abort because it knows that a tee like that cannot be constructed. In order to export the model, the tee must be fixed so the branch axis does not match the header axis. The goes for all other pipe components, if the actual component cannot be drawn because of dimensional issues or arrangement, then isogen will abort trying to create a stress iso. Recommend: a. Review all valves and flanges closely. Be sure all are modeled correctlyb. Review Tools Model Consistency Check report to reduce number of warnings.c. In general, review model looking for obscurities. Typical issues:--------------------- a. Flanged valve in middle of pipe run without attached flanges, add flanges to both sides of valve. b. In middle of pipe run, back to back flange set. Upon closer inspection, there are 3 flanges. Remove the correct flange. c. Known limitation, reducer cannot be the start or end of segment. Add sh