多丽彩扩机下机箱英文错误信息对照表.docxVIP

切刀故障颜色索引超 切刀故障 颜色索引超 扩印灯故障 多丽彩扩机下机箱英文错误信息对照表 cutter failure color index out of bounds 出限制 display failure display timeout exposer overheat paper feeding failure main motor failure (start) main motor failure (stop) motor failure tape failure (prepare) 段 paper feeding failure (prepare) cutter failure (prepare) photo preparation failure tape timeout (bit) tape timeout (bit) tape release failure twister failure zoom failure developer regeneration显示超时 曝光头超温 装纸故障 主电机故障（开机时） 主电机 故障（停止时）电机故障同步带故障（准备阶 装纸故障（准备阶段） 切刀故障（准备阶段） 图像准备故障同步带超时（位）同步带超时 漂定补充稳定补充cassette未设置纸箱cassette id 纸箱号改变 漂定补充 稳定补充cassette 未设置纸箱cassette id 纸箱号改变developer 彩显补充低液bleach regen. bleach regeneration stabilizer regeneration not set up (%1) change regen. low level low level stabilizer regen. low level sink overflow developer solve nt low level stabilizer solve nt low level bleach solve nt low level developer solve nt level OK bleach solvent level OK stabilizer solve nt level OK developer pumping out ended bleach pumping out ended stabilizer pumping out ended there was piece of paper in cutter slot changed Duoli Platform Controller OK 正常 漂定补充低液 稳定补充低液 接收器溢岀彩显接收器低液 稳定接收器低液漂定接收器低液彩显接收器液位止常漂定接收 器液位正常稳定接收器液位正常 彩显泵输出结束 漂定泵输出结 束 稳定泵输出结束切刀卡纸槽改变 多丽扩片台控制器 多丽冲洗控控制器止常 多丽冲洗控 控制器止常 未能与扩片台 制器正常 Led Controller OK LED no connection with Duoli platofrm 相连接 no connection with Duoli Wash 分相连接 no connection with Led paper not loaded cassette not set up (%1) format not set up (%1) exposition done…read counters paper not loaded (%1) run out of paper Bad Hasp paper not loaded 未能与多 未能与多 相纸未能加载 未设置纸箱 未设置规 相纸用完加密狗损坏相纸未能加载 曝光 工作中 故障 报警 备用waste 废液桶满developer 彩显液位 stabilizer level. WARNING STARTUP OVERHEAT READY EXPOSITION WORKING 丽冲洗部未能与LED相连接 格 曝光完成…读数 未装纸 警告启动 超温准备 FAILURE ALARM STANDBY full level temperature .If no cassette Cassette d glossy filigra n matt silk paper left: dm pict. (-X-) shutdown in progress restart in progress it is safe to turn power off PAPER END bleach level format (?x%d) run out of paper 稳定液位 温度 无纸箱 纸箱 光面 半