钢筋锈蚀的空间分布对梁六受剪性能的影响——基于数值模拟的研究.docx

黪蠢n点彳硕士学位论文(5)从假定锈蚀箍筋局部锚固失效现象，进行多种情况的箍筋锚固失效的 黪蠢n点彳硕士学位论文 (5)从假定锈蚀箍筋局部锚固失效现象，进行多种情况的箍筋锚固失效的 数值模拟得出的结果显示，局部锚固失效降低了梁的承载力和刚度，但降低幅度 受局部锚固失效位置的影响；靠近支座处箍筋下端锚固失效+靠近加载点箍筋上 端锚固失效导致抗剪承载力下降最大；靠近支座处箍筋上端锚固失效的影响较 小；剪跨区内箍筋上端全部锚固失效或下端全部锚固失效对抗剪性能的影响介于 以上两者之间。上述结果还受梁尺寸的影响，在箍筋的锚固失效位置分布相同的 情况下，大尺寸梁的抗剪承载力下降程度相对较低。 关键词：RC梁数值模拟抗剪承载机制钢筋空间锈蚀箍筋锚固失效 万方数据 AbstractAbstract Abstract Abstract The durability of reinforced concrete(RC)structure has become a problem being widely concerned at home and abroad in recent years．Reinforcement corrosion is important factor affecting the durability of RC structure．Most of the publised researches the influence of reinforcement corrosion on the structural performance of RC beams focused flexural performance，but few of them focused shear performance．Under marine environment subjected to chloride ingression，’the corrosion degree of stirrups is more serious than longitudinal reinforcements because stirrups have smaller section and would be eroded by chloride more easily．As result, briRle shear failure would happen rather than flexural failure during there sevice life． Furthermore，most of the publised researches focused the effect of uniform corrosion the structral performance of RC members，but in fact，if the corrosion level of steel bars develop to such lever that coule affect the structural performance of RC members，the corrosion state is always not uniform，it exhibits nonuniform and asymmetric with spatial distribution． Numerical simulation is very useful method of studying the durability of RC structures。Through this method，we not only observe macro mechanics phenomenon but also acquire some micro information which cannot be obtained by experimental investigations． Based the test results of research team，numerial investigation using commercial FEM software Diana was used to carry out an investigation on the influence of spatial reinforcement corrosion shear performance of RC beams， which includes the following：1)The influence of the uniform corrosion of longit