MAX-PAC™ CAM软件的最新发展.pptxVIP

MAX-PAC? CAM Software Development;Specialized CAM System for Turbomachinery Direct Interface with AxCent blade design system Automated generation of 5-axis cutting strategies Advanced patented algorithms High quality parts with less programming time and less cutting time;MAX-PAC V7.3;Truncate hub paths at splitter or main edge Use standard hub finish after splitter edge;Interlace hub paths Multiple levels possible ;Lift tool to avoid gouging during fillet milling when fillets overlap;Use when Ruled data not available Minimized deviations in .LIS file ;Stepdown option: Constant cusp vs. constant step ;Retract length control Old version: Retract to shroud Fixed retract length New: Retract to start depth Reduce “air cutting” time ;Circular “roll-in” to material Chip thickness reduces to zero Quieter entry, improves cutter life;More consistent stepover Continuous corner radius adjustment;Lift to specified Z value ;Spline OFFIMP.DAT in Tip-Hub direction;Text input of nominal XYZ values Need custom probing syntax for PP ;MAX-PAC shank file data exported in NC header, read by Vericut ;Lollipop tool with origin at tip Corner-radius with lollipop shank possible ;Output toolpath for all blades Faster than rotating coordinate system on some controls ;Check release notes for full list of v7.3 features MAX-PAC 7.2 also released since last user meeting in China (2008) Feedback always welcome!;MAX-PAC Development;Flat/Torus cutter more efficicent than ball tool Optimize angle for smallest cusp Avoid gouging in concave areas Smoothed vectors Helix or Tip-to-hub direction Can be used for roughing;Match blade finish by starting at same isoparameter as last finish pass Hub Shroud fillets Variable fillets supported Blending functions;Orientation options Flank or point-mill Monotonic table Circumferential Follow platform edge ShroudHub platforms;Combine: CADTranslator MAX-5/AB/SI/Single P3MAX General Geometry Kernel Better CAD interface More Flexibility for future functions Roughing