Step3_tx_power_control_artgui(1)英文文献资料.pdfVIP

In this instruction there isnt noted how to run NART in DUT. 1 Preparation of tools Steps below should be done only one time at same PC if you didnt have “AtherosCal” installed. 1. From download newest version of AtherosCal software: AtherosCal.zip. You may need to instal some additional required packages from support.zip or folder support. 2. Extract AtherosCal.zip into new folder in your PC. 3. Navigate to subfolder „bin“ and open „start.art“ file for editing 4. Comment line equipment model=litepoint; arg=1 # Litepoint just by adding „ # symbol at the line begining: #equipment model=litepoint; arg=1 # Litepoint NOTE: this step disables board calibration functionality, but allows to use “AtherosCal” for manual measurements. To do calibration with same SW just remove comment in that line. 5. Run “artgui.exe”. 6. If program wont to start, try to install required software components: 1. DotNetFramework (installation file support\dotnetfx.exe) 2. Matlab runtime v79 (installation file support\MCR79\MCRInstaller.exe) 3. Microsoft redistribution (installation files for 32bit PC support\vcredist_x86.exe or for 64bit PC support\vcredist_x64.exe) 7. a 2 Steps for measurements Do those steps each time when you will to do some manual measurements. 1. In DUT start NART daemon 2. In PC navigate to yours “AtherosCal” folder and start “artgui.exe” 3. Enter board IP to “artgui” program window and press “Load Card” button. Wait until button name becames “Unload Card”. If in green “ARTGUI” area you see text, like below – you need to run NART daemon into DUT or DUT IP is wrong or cant connect to DUT (b.e. no LAN connection between PC and DUT). 5000 INFO Trying to connect to nart[0] on 6:2390. 5002 ERROR Cant connect to nart[0