材料与试验协会 B21B21M-01ｅｌ海军黄铜条材、棒材和型材.PDFVIP

Designation: B 21/B 21M – 011 Standard Specification for Naval Brass Rod, Bar, and Shapes 1 This standard is issued under the fixed designation B 21/B 21M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1 NOTE—Section 1.4 was added editorially in January 2003. 1. Scope * Stress Corrosion Cracking in Copper Alloys Using an 1.1 This specification establishes the requirements for naval Ammonia Vapor Test2 brass rod, bar, and shapes produced from Copper Alloys UNS E 8 Test Methods for Tension Testing of Metallic Materials3 No. C46200, C46400, C47940, C48200, or C48500. E 8M Test Method for Tension Testing of Metallic Materi- 1.1.1 For piston-finish rod or shafting refer to the Other als (Metric)3 Requirements Section. E 18 Test Methods for Rockwell Hardness and Rockwell 1.1.2 For hot forging material, refer to Specification B 124/ Superficial Hardness of Metallic Materials3 B 124M. E 478 Test Methods for Chemical Analysis of Copper 1.2 Units—The values stated in inch-pound units or SI units Alloys4 are to be regarded separately as standard. Within the text, SI