材料与试验协会 B135M-00ｅｌ无缝黄铜管（米制）.PDFVIP

Designation: B 135M – 001 METRIC Standard Specification for Seamless Brass Tube [Metric]1 This standard is issued under the fixed designation B 135M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1 NOTE—The headings and footnotes in Tables 2 and 3 were editorially corrected from inch/pound to SI units in February 2002. 1. Scope Copper-Alloy Pipe and Tubing2 1.1 This specification covers seamless round and rectangu- B 154 Test Method for Mercurous Nitrate Test for Copper lar including square copper alloy tube in straight lengths. Ten and Copper Alloys2 alloys are specified having the following nominal composi- B 251M Specification for General Requirements for tions: Wrought Seamless Copper and Copper-Alloy Tube [Met- ric]2 Copper Nominal Composition, % Alloy Previously B 601 Practice for Temper Designations for Copper and UNS Used Copper Alloys—Wrought and Cast2 No.