自动变速器传动轴悬架课件.ppt

* * Three planetary units, four clutches, four brakes, and four one-way clutches * 备注：Neutral control is used to disengage the transmission from the engine while the vehicle is stopped. This reduces the load on the engine and improves fuel economy while the vehicle is stopped. * 备注：For this control, when the vehicle is in 6th gear and starts decelerating, the transmission downshifts from 6th to 5th and from 5th to 4th before fuel cut control ends so that fuel cut control continues operating. * 所有型号均为标准装备 S 模式：档域保持型 STD for all models S mode: Range hold type * 档位信号送至发动机ECU 以控制档域 Shift signal is sent to Engine ECU to control the shift range * Holding the shift lever to + (forwards) in S will change the shift range to the S6 range regardless of shift range (S1 to S5). 档域保持型档位变化 D到S时初始档域：S（5） Range hold type shift changes Initial range from D to S mode: S (5) range * (a) ATF Warmer (1) The ATF warmer uses engine coolant that has been warmed by the engine to warm up the ATF quickly and to keep the ATF temperature higher (within limits). Consequently, the friction losses of the automatic transmission are quickly reduced, thus improving fuel economy. * * 新ATF使用同样的保养间隔 Same maintenance interval on automatic transmission with new ATF * 新ATF检查过程：（无油尺和加油管） 外观检查有无渗漏 无渗漏：无需检查油量 [注意] ***发动机不运转时拆去溢流塞会使油液流出 请按加注和油面检查过程操作以免油液意外损耗 New ATM fluid inspection procedure : (No level gauge (dip-stick) and filler tube) Visual check for fluid leak No fluid leak : no need to check fluid level [Caution] ***Removing of the overflow plug without engine running will flow out fluid. Follow the procedures for fluid refill and fluid level check to prevent accidental loss of fluid. * [Service Part / Refill Quantity] Oil pan replacement: 1.3 L (1.37 US qts., 1.14 lmp. qts.) Valve body replacement: 3.9 L (4.12 US qts., 3.43 lmp. qts.) Torque converter replacement: 4.4 L (4.65 US qts., 3.87 lmp. qts.) * 溢流管高度决定ATF量 Height of overflow tube decides the quantity of ATF * 新自动变速器是按使用ATF WS设计的，如果不按要求加注A