爱立信GSM refarming 知识讲解.ppt

配置 及 硬件连接 载频分配 配置 及 硬件连接 RUS01 /RUS02 RBB ? RBB12_2A (with 2 CPRI, used for 1 TX 2 RX Diversity) -This RBB is used for Mixed Mode with no CPRI sharing. ? RBB22_4B (with 4 CPRI and analog RX cross connect) - RBB22_4B RBB22_4B is used for sectors with two TX branches, two RX branches, and four CPRI connections. This RBB uses an analog RX cross-connection. This RBB is used for Mixed Mode. Note: ? The RX I/O ports are configured and used for GSM and WCDMA, but not for LTE. RBB 22 4b 1 RF A TX RF B TX A / RX A RBB 12 2a 1 1 2 Data 1 RF A TX RF B 1 2 Data 1 Data 2 RXA I/O RXA Out RX RXB I/O 2 Data 1 RF A TX RF B Data 2 RXA I/O RXA Out RX RXB I/O TX B / RX B 3 4 Data 2 RXA I/O RXA Out RX RXB I/O (R)RUS01 and RUS02 (R)RUS01 and RUS02 MSMM RBB TX A / RX A RX B 配置 及 硬件连接 配置例子 注意功率相等 LTE=GSM DUL A B C D E F RBB22 4b S1 (LTE use RBB 22 4a) RBB12 2a S2 DUG A B C D E F RBB22 4b S3 (LTE use RBB 22 4a) RBS type RBS6201 　 　 　 　 　 　 　 DUa DUL20 Support system control=TRUE/FALSE depending on TC 　 DUb DUG20 Support system control=TRUE/FALSE depending on TC 　 - GSM frequency hopping shall be configured on the GSM nodes (BB) 　 Sector # RB # Carrier Freq Power L BW TXD/MIMO (L) Antenna HW Antenna conf(as denoted in common IP) S1 RBB22 4b 1L+6G 1800 15+3*153*15 5 Mhz No RIU/ARET C S2 RBB12 2a 1L+1G 1800 30+30 15MHz No TMA (internal power=YES), RIU/ARET E S3 RBB22 4b 1L+4G 1800 1*20+2*201*20+2*20 5MHz Yes TMA (internal power=YES) D (1) The RBB applies to both standards. (2) Mixed Mode configurations with 1.4 MHz LTE carriers are not supported. (3) Used for LTE (4) The RX I/O ports are configured and used for GSM, but not for LTE. (5) Used for GSM (6) BSC can override minimum number of GSM carriers (7) Can be configured with or without MIMO. MIMO does not affect the confi