单面瓦楞机卡闸机构动力学分析.pdf

包装工程 第37卷 第5期 124 PACKAGINGENGINEERING 2016年3月 单面瓦楞机卡闸机构动力学分析 尚雯，杜群贵 （华南理工大学，广州 510640） 摘要：目的目的分析单面瓦楞机卡闸机构振动产生的原因并对其进行减振优化。方法方法 对单面瓦楞机的 关键机构卡闸机构进行了动力学建模，上下瓦楞辊是变中心距啮合，然后在Ansys中作上下瓦楞辊的 模态分析，并对单面瓦楞机进行了振动测试。结果结果 将测试的结果与建立的数学模型、模态分析得到 的固有频率对比，得到单面瓦楞机振动的根本原因是在频率为154，217Hz等处发生共振，最后对卡闸 机构进行减振优化，达到了减振效果。结论结论 文中建立的动力学模型和仿真对研究单面瓦楞机振动特 性的研究是有效的。 关键词：瓦楞机；动力学；建模；振动测试；卡闸机构 中图分类号：TH132.4 文献标识码：A 文章编号：1001-3563（2016）05-0124-06 Dynamic Analysis of the Cassette Mechanism of the Single-sided Corrugating Machine SHANGWen，DUQun-gui （South China University of Technology, Guangzhou 510640,China） ABSTRACT ：The aim of this article was to analyze the causes for vibration of the cassette mechanism of the single-sided corrugating machine and the vibration reduction optimization was conducted. The dynamics model of the key cassette mechanism of the single-sided corrugating machine was established. The mesh center distance of the upper and lower corrugating roll was changing. Then the simulation of the modal analysis of the upper corrugating roll and lower corrugating roll was conducted in Ansys, and then a vibration test was conducted on the single-sided corrugating machine. Comparing the test results with the natural frequency obtained from the roller′s modal analysis and the dynamic model established for the cassette mechanism, the primary reason of single-sided corrugating machine′s vibration was found to be the resonance occurring at the frequency 154, 217 Hz, etc. Finally, the vibration red