DFM修改案例专题课件.ppt

Customer Name： CTS（VSDVDS） Product Name：DSFDSFDS Product Code：DSFDS Material：ABS Color: BLACK * * 产品排位 Product Layout P/L, 模具结构, 进胶方式 P/L. Mold Structure, Gate 3) 拔模 Draft 重要尺寸及保证对策 Critical Dimension and Countermeasure 5) 产品存在问题点 Problem 目录 * * Number of cavities :4 Cavities Position of cavities 1-1 1-2 Hot Runner Hot Runner OK OK 斜顶，顶针 斜顶1 顶针 PL线:大红色 前模面：品红色 后模面：绿色 滑块：蓝色 前模 后模 滑块 PL线 * * Ejector pin Core surface 2-4 P/L (分模线) : 紫色(Purple) CAVITY (前模) : 红色(Red) CORE (后模) : 绿色(Green) INSERT (镶件) :青色(Cyan) SLIDE (行位) :兰色(Blue) 2-1 型腔号码 (仅指示位置)Cavity ID,(only indicated position) Slide 材料标识Material Mark Cavity surface 2-2 2-3 2-5 NO flash on these position该位置不允许有披锋。OK NO flash on this position, must be polish 该位置不允许有披锋，必须进行抛光处理。 OK * * Sub-Gate Core insert 2-7 2-8 2-6 2-9 Core insert 2-10 Slide insert Slide OK OK OK OK OK * * 为确保出模 建议后模所指颜色区域,减胶方向拔模1o. We suggest making draft angle of 1o in material reducing direction on the core marked area to ensure the mold opening. 3-1 为确保出模 建议前模所指颜色区域,减胶方向拔模1o. We suggest making draft angle of 1o in material reducing direction on the cavity marked area to ensure the mold opening. 3-2 Good Good Remain steel for this surface此表面做预留。OK,我们做到该尺寸公差的下限. * * 此处做镶件,保证此孔的尺寸公差Make insert here, to ensure that this hole dimension within the tolerance range. 此处做镶件,保证此孔的尺寸公差 Make insert here, to ensure that this hole dimension within the tolerance range. 此处对该尺寸预留,先将此尺寸做小,待T1之后调整尺寸时加胶到图纸数We will remain the dimension smaller firstly, the drawing dimension will be modified by adding material after mold trial 1. 4-1 4-2 4-3 Good Good Good * * 4-4 此尺寸及公差做镶件来保证(镶件胶位部分拔模为0o) We suggest making insert to ensure the product dimension and tolerance (the draft angle of insert material position is 0o. Good * * 0.05mm(高出Ｐ．L) 所示红色面高出P.L0.05mm，能否减胶与Ｐ．Ｌ平？ The red surface is 0.05mm higher than P.L, we suggest reducing material to make it in the same level with P.L. 5-2 No, build as 3D model