AASHTO 间接拉伸试验测定动态模量主曲线.pdfVIP

Proposed Standard Practice for Developing Dynamic Modulus Master Curves for Hot-Mix Asphalt Concrete Using the Indirect Tension Testing Method AASHTO Designation: PP XX-XX 1. SCOPE 1.1 This practice describes testing and analysis for developing a dynamic modulus master curve for hot-mix asphalt concrete using the Simple Performance Test System. This practice is intended for dense- and gap- graded mixtures with nominal maximum aggregate sizes to 25 mm. 1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this pro cedure to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to its use. 2. REFERENCED DOCUMENTS 2.1 AASHTO Standards • AASHTO PP XX-XX, Preparation of Indirect Tension Performance Test Specimens Using the Superpave Gyratory Compactor. • AASHTO PP XX-XX, Determining the Dynamic Modulus for Hot Mix Asphalt (HMA) Using the Indirection Tension Testing Method • AASHTO PP XX-XX (TP 62-03), Developing Dynamic Modulus Curves for Hot-Mix Asphalt Concrete 2.2 Other Publications • Equipment Specification for the Simple Performance Test System, Version 3.0, Prepared for National Cooperative Highway Research Program (NCHRP), October 16, 2007. 3. TERMINOLOGY Developing Dynamic Modulus Master Curves for Hot-Mix Asphalt Concrete Using the Indirect Tension Testing Method 1 of 9 3.1 Dynamic Modulus Master Curve – a composite curve constructed at a reference temperature by shifting dynamic modulus