大方坯结晶器电磁搅拌冶金效果研究.pdf

第33卷第6期 钢摇 铁摇 钒摇 钛 Vol郾33,No郾6 2012年12月 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 IRON STEEL VANADIUM TITANIUM 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 December2012 苏收收收收收收苏收 收 钢铁工艺苏 苏收收收收收收 大方坯结晶器电磁搅拌冶金效果研究 李志强 (攀钢集团研究院有限公司,钒钛资源综合利用国家重点实验室,四川 攀枝花617000) 摘摇 要:通过统计不同时间段结晶器电磁搅拌磁场强度及连铸坯质量,将不同磁场强度所对应的连铸坯内部质量 进行对比,分析了不同磁场强度对连铸坯质量的影响。 同时,浇注过程中改变电搅线圈的电流强度,在同一流次得 到不同的磁场强度,取对应的连铸坯样进行检验,对比分析了同一流次不同磁场强度对连铸坯质量的影响。 分析 -4 认为:电磁搅拌磁场强度衰减至300伊10 T 以下时,不宜再上线使用。 进而对攀钢大方坯结晶器电磁搅拌的冶金 效果进行了评价,规范了电磁搅拌器的使用。 关键词:连铸;结晶器;电磁搅拌;铸坯质量 中图分类号:TF777郾2摇 摇 文献标识码:A摇 摇 文章编号:1004-7638(2012)06-0040-05 Study on Metallurgical Effects of M鄄EMS during Bloom Continuous Casting Li Zhiqiang (Pangang Group Research Institute Co. Ltd. ,State Key Laboratoryfor Comprehensive Utilization of Vanadium andTitani鄄 um Resources,Panzhihua617000,Sichuan,China) Abstract:In this paper,M鄄EMS magnetic field intensity and bloom quality at different periods is coun鄄 ted,and on this basis,the effect of magnetic field intensity of M鄄EMS on casting bloom quality is ana鄄 lyzed. Different magnetic field intensity in a single strand can be obtainedby changingthe current inten鄄 sity of M鄄EMS. Then,the corresponding bloom under different magnetic field intensity are sampled for testing. Thus,the effect of magneticfield intensity on bloom quality isstudied in a single strand. Analy鄄 -4 sis suggests that M鄄EMS should not be used when its magnetic field intensity is less than 300伊10 T. Furthermore,the metallurgical effects of bloom M鄄EMS in Pangang are evaluated and the applicable standard for M鄄EMS is established.