c1244m-93中文版-通过负压（真空）试验测定混凝土污水管检查孔的标准试验方法.docVIP

C 1214M PAGE 850 Designation: C 1244M -93 METRIC编号：C 1244M – 93（米制） PAGE 845 Standard Test Method forConcrete Sewer Manholes by the Negative Air Pressure (Vacuum) Test [Metric]1通过负压（真空）试验测定混凝土污水管检查孔的标准试验方法【米制】 This practice is under the jurisdiction of ASTM C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C13.06 on Manholes and Specials.本规范由ASTM委员会C-13混凝土管道委员会管辖，并由C13.06检查孔和异型管分委会直接负责。Current edition approved Aug. 15, 1993. Published October 1993.现行版本于1993年8月15 This standard is issued under the fixed designation C 1244M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (€) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 1244 M刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 This test method covers procedures for testing precast concrete manhole sections when using the vacuum test method to demonstrate the integrity of the installed materials and the construction procedures. This test method is used for testing concrete manhole sections utilizing mortar, mastic, or gasketed joints.本试验包括使用真空试验方法测试预制混凝土检查孔段的程序，以证明安装材料与施工程序的切合度。本试验方法用测试砂浆、胶粘水泥或衬垫接料测试混凝土检查孔段。 1.2 This test method is intended to be used as a preliminary test to enable the installer to demonstrate the condition of the concrete manholes prior to backfill. It may also be used to test manholes after backfilling; however, testing should be correlated with the connector supplier.本试验方法是确保安装者在回填前说明混凝土检查孔情况的预试验，但也可在回填后进行。试验应与连接器供应商同时进行。 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.